Frequently Asked Question

V-Tune Pro 4K Shows "- - - - -" on boot up"

This is normal / out of box state. The newer firmware displays this when there are no scanned channels in database.

If you also have "no video", the unit is defaulted to 1080i when 'New' or 'Reset'.
Some displays or scalers may not sync to this sometimes.

You can use a composite monitor to view OSD, or use the followoing key sequence to navigate the OSD 'Blind' to set 1080P:

Power cycle unit...allow time to boot up.

Using the IR Remote, carefully press the following sequence:
- Menu - Down - Down - OK (Selects Setup)
- Down - OK (Selects Resolution)
- Down - OK (Selects 1080P / Should see video now)
- Left - OK (Save setting)

Originally published 3/16/2017